23rd January 2009

Fuel tank fabrication odds & ends

Hours: 1.6 | Posted in Fuel Tanks

Squeezed the rivets for the right tank end rib reinforcement ring & nutplates.  Located and drilled the fuel caps and drain flanges, then fabricated and drilled the clips that hold the vent line to the fuel cap flange.

That basically wraps up the pre-sealing fabrication work for the fuel tanks.  Up next is deburr, dimple, and prime the external brackets; then it’s time to seal these puppies up.

This entry was posted on Friday, January 23rd, 2009 at 8:34 pm and is filed under Fuel Tanks. You can follow any responses to this entry through the RSS 2.0 feed. Both comments and pings are currently closed.

Comments are closed.